PLA and PETG withstand lukewarm water – never hot.
How to do it
- Time
- 3 min
- Water
- Lukewarm, 35 °C at most – never hot
Lukewarm water and one drop of mild dish soap. Let it dry for a long time.
With these answers we do not recommend the ultrasonic cleaner, so there is no how-to.
Pick your cleaner to see if it fits, which setting to use and what its manual says.
Why
PLA starts to soften at around 55–60 °C, so lukewarm water is safe. Water can stay between the layers, and resin prints that are not fully cured can leach.
Watch out for
- Uncured resin: avoid
- Let it dry completely before painting
Sources
Cleaners that fit this
Ranked by fit, never by commission.
- Vevor KZ-F2 2 L · 40 kHz · heaterSee price on Amazon
- Vevor Ultrasonic cleaner 3 L with heater and degas 3 L · 40 kHz · heaterSee price on Amazon
- Vevor TH-30AXN 6 L · 40 kHz · heaterSee price on Amazon
How we rank: models made for this kind of item first, then how easy the model is to buy where you are, then how much of its spec is confirmed in a source.
We may earn a commission when you buy through these links. It never changes an answer. How this works
We may earn a commission when you buy through these links. It never changes an answer. How this works
Good to have for this
- Ultrasonic cleaning solutionSee options on Amazon
- Mesh basket for small partsSee options on Amazon
We may earn a commission when you buy through these links. It never changes an answer. How this works
Clean it safely another way The safe way while you check
- Soft microfiber clothsSee options on Amazon
We may earn a commission when you buy through these links. It never changes an answer. How this works