UltraOkay

Is it OK for your ultrasonic cleaner?

Acrylic or bioplastic piercing

Yes
Check first
No

Plastic piercings withstand lukewarm water – but print and colour can wear.

Updated from your answers.

How to do it

Time
3 min
Water
Lukewarm, 30–40 °C

Only lukewarm water and one drop of mild dish soap. Rinse and air-dry.

With these answers we do not recommend the ultrasonic cleaner, so there is no how-to.

Pick your cleaner to see if it fits, which setting to use and what its manual says.

Why

Acrylic and bioplastic withstand lukewarm water but can develop micro-cracks and lose their print from chemicals and heat. There is no manufacturer source on ultrasonic cleaning, so we are cautious.

Watch out for

  • Never hot water
  • Replace the piece if it has cracks

Sources

  1. Wevolver – PLA and heat

Cleaners that fit this

Ranked by fit, never by commission.

How we rank: models made for this kind of item first, then how easy the model is to buy where you are, then how much of its spec is confirmed in a source.

We may earn a commission when you buy through these links. It never changes an answer. How this works

    We may earn a commission when you buy through these links. It never changes an answer. How this works

    Good to have for this

    We may earn a commission when you buy through these links. It never changes an answer. How this works

    Clean it safely another way The safe way while you check

    We may earn a commission when you buy through these links. It never changes an answer. How this works

    Good to know

    Related

    Which cleaner do you have?

    Pick your model and every answer adapts to it: tank size, heater, timer and the warnings in its manual.

      Can't find yours?

      Describe it and we use a similar profile.